For growers on Sentek probes
What a stem water potential (SWP) reading is, and why the Monday list asks for one
A stem water potential (SWP) reading is a midday measure of how hard a tree is pulling for water, taken on a shaded, bagged leaf and read in bars, where a more negative number means more stress. Every SWP reading your adviser takes sharpens the Monday list and the block’s record.
By AgWaterAI. Last updated: November 3, 2026.
What the reading measures
Water inside a tree is under tension. UCCE describes stem water potential as the potential energy of water in a leaf stem, the number that tells you how "thirsty" your trees are, and UC Davis explains that because the reading measures a tension it is written as a negative value in bars.
The reading is taken on a leaf that has been bagged, so that it comes to equilibrium with the water in the branch behind it. The leaf is cut, the cut stem is put under rising pressure, and at the moment water just appears at the cut surface the gauge reads the midday SWP.
The bag matters. It stops the leaf transpiring, so the leaf reads the branch underneath rather than its own surface, and UCCE farm advisors note that uncovered leaves measured in midafternoon gave variable readings when the method was new, while the bagged leaf reaches equilibrium with the water conducting system and reduces that variation.
How it is taken
The steps below are the UC procedure, in field words.
- Choose mature, shaded leaves low in the canopy. UC Davis's walnut procedure bags leaves on about 10 trees per orchard, about weekly, and says the number of trees depends on how variable the soil and the irrigation are.
- Cover each leaf in a bag that blocks light and moisture. UC Davis says at least 10 minutes before the reading for walnut and at least 15 minutes for pistachio, so the leaf equilibrates with the branch.
- Read in the early afternoon. UC Davis gives 1 to 3 pm; UCCE farm advisors give midday, 12 to 4 pm.
- Take one leaf at a time, still in its bag, and raise the pressure slowly until water just begins to come out of the cut end. If you go past the endpoint and water bubbles out, back off and re-pressurize to find it.
- Record the reading with the time, air temperature and relative humidity, then move to the next tree.
- On pistachio, UC Davis notes that resin from the leaf's resin channels can make the reading difficult.
The baseline: the weather sets the yardstick
The same tree reads more negative on a hot, dry afternoon than on a cool one, because the reading is influenced by both air temperature and relative humidity. UC compares each reading with the fully watered baseline: the SWP expected from a tree with all the water it wants, under that day's weather.
UCCE farm advisors put it plainly: the baseline is a reference for interpreting your trees' readings, not a target to hold the orchard at, and comparing a reading with the baseline lets you express the orchard in bars below baseline. UC Davis adds that every plant-based indicator of tree water status is affected by the weather, so a baseline has to be developed and used for a correct interpretation.
For almond, UC Davis puts the fully watered baseline in the -7 to -9 bar range, and the July 2026 UCCE Sacramento Valley almond newsletter gives about -9 bars in its example conditions of 95°F and 30 percent relative humidity, with moderate to high stress from -14 to -20 bars. UCCE's beginner's guide, based on UC ANR Publication 8503 (2014), says field research suggests the ideal range for almond is between -8 and -18 bars: -8 to -12 from March through mid June for shoot growth and nut sizing, -14 to -18 at hull split from late June or early July, and back to -10 to -14 after harvest for next year's buds, with long periods past -20 slowing young orchards and defoliating older ones.
For pistachio, UC Davis's November 2020 irrigation guidance puts the baseline at about one tenth of the air temperature, suggests waiting until the reading is 2 bars below baseline before irrigating, 4 bars on mature trees, and calls -14 to -16 bars stress, the point where the stomata close.
For citrus, UCCE's June 2025 overview gives broad ranges only: -4 to -10 bars fully irrigated, -10 to -20 slightly to moderately stressed, and -20 and lower severely stressed. It calls every range an approximation, notes that UC researchers keep refining them, and points growers to UCCE resources on crop stage and on reference baselines that factor in temperature and humidity.
The UC walnut, almond and dried plum guidelines carry the word tentative in their title and have been revised more than once (May 2007, August 2018), so read any range as a guide, read it against that day's baseline, and read it with what you see in the trees.
Why growers take it beside soil probes
A soil probe reads the soil where it sits. UC Davis's case for the reading starts there: measuring soil moisture tells you what is going on in only a limited volume of soil, it can be hard to decide where to monitor when roots run deep and variable under drip, and scheduling from ET alone goes wrong when the starting soil moisture, the system's application efficiency or the estimate of crop water use is off.
The SWP reading integrates the soil factors across the whole root system and the weather into one number for the tree itself. UC Davis therefore calls it an adjunct to soil moisture or ET scheduling: something to use alongside the probes, not instead of them.
What the Monday list does with it
Once your blocks have a season of their own stem water potential (SWP) readings: which blocks to take a reading on first each week, from each block's own reading record. Every SWP reading your adviser takes sharpens the Monday list and the block’s record. A farm with no readings starts with the three-day soil projection on each probe, once the probe has logged a wetting.
On a new farm, your adviser weighs the model estimates against local readings. SWP readings, when available, are judged against the block's stress line.
On Platform, your own Certified Crop Adviser or adviser reviews the draft and makes the call. Nothing we send controls a pump or a valve.
The honest limits
Your adviser’s readings remain the measurement of record. SENTRY needs local SWP readings and does not replace them.
From the method note on the Monday list replay: First run October 19, 2026; rerun November 10 and 11, 2026; scored November 12, 2026 against a careful hand sort and rotations that ignore the readings. A development result, not a field trial. The number of SWP visits stays the same; the list says where to start.
A reading is one tree at one moment, under that afternoon's weather. UC Davis's procedure samples several trees and records the conditions for a reason, and UCCE asks you to weigh the number against what you see in the orchard.
Connect your IrriMAX Live account
For growers who already own Sentek probes: AgWaterAI reads your IrriMAX Live data and adds a Monday briefing and a sealed record; the Monday list follows a season of your SWP readings, and a Thursday draft needs our agronomist’s past orders loaded into the draft’s rules. Platform: $20 per acre per year on your own probes, with your own crew and adviser. 20-acre minimum.
Sources
Every agronomic statement and every number on this page was read on a University of California page on November 3, 2026. The ranges are UC's, the readings are your adviser's, and the call is theirs.
- UCCE, Stem Water Potential Overview (Ellie Andrews, June 2025)
- UC Davis, Using Plant Based Measurements to Refine Irrigation Scheduling in Walnut (Bruce Lampinen)
- UCCE Tehama County, Using Stem Water Potential for Irrigation Management (Richard Buchner and Allan Fulton, slides)
- UC Davis, Pistachio Irrigation: Determining Water Needs and Managing Drought (Giulia Marino, November 16, 2020)
- UCCE, Sacramento Valley Almond Newsletter (Jaime Ott, July 2026)
- UCCE Sacramento Valley Orchard Source, Interpretation for the Beginner (Allan Fulton and Luke Milliron, August 30, 2018; based on UC ANR Publication 8503, 2014)
- UCCE Sacramento Valley Orchard Source, Using Baseline SWP for Precise Interpretation (Fulton and Milliron, 2018)
- UC, tentative guidelines for interpreting midday SWP readings in walnut, almond and dried plum (Fulton, Buchner, Grant, Prichard, Lampinen, Schwankl and Shackel, updated May 2007)
Sentek and IrriMAX Live are the names of products you already own. AgWaterAI is a separate company, not affiliated with their maker, and reads only the data you authorize.
